3.2 Sources Positions

The Sources Position tab allows to control the position of each source with XY pad.
The sources are split on two tabs: sources 1 to 8 and 9 to 16
A slider allows to set the width of the source
The button triggers the movement programmed in NESS

Source Mixer

The Source Mixer tab controls the gains of the sources and the master fader

For each source, the following controls are available:
• Gain fader
• Mute button
• Solo button

The main controls are the following
• Master fader
• Master mute
• Clear solo

Snapshots

The snapshots tab allows to load snapshots of the current session from the mobile device.
The current snapshot is highlighted in yellow
The « Update Snapshot table » button forces the upload of the snapshots of the session

Troubleshooting
If the app controls NESS but the changes in NESS are not updated in TouchOSC, check the IIP address and the UDP port entered in the Settings panel in NESS, and the UDP port in the “Connections” menu of TouchOSC
If the application does not communicate with NESS, check that the label « ToucOSC connected » is displayed in green in the Settings panel. If it is not the case, check the IP address in the Connections tab in TouchOSC